Contact info:

Jon Howell
Dartmouth College
6211 Sudikoff Laboratory
Hanover, NH 03755
USA
603-646-3297 (phone)
603-646-1672 (fax)

Files:

readme.txt   (Info file)
palm-adaptor.top (Top layer)
palm-adaptor.bot (Bottom layer)
palm-adaptor.tap (Drill file)

Notes:

*** Please check the files before manufacture. ***

* This board should be 0.031" thick.

* Please at least 4 boards.

* I don't mind waiting a few days to avoid having to fill
a minimum order of two panels.

* The boards are narrower than 1.5". Please cut the boards
into groups of two (which should be included using your regular
shear service), and I will make the smaller cuts myself to
avoid the additional small-board cutting charge.

* The Gerber files have been generated using extended Gerber
  so there is no aperature file.

* The drill file (palm-adaptor.tap) specifies the drill sizes
  so there is no tool file.

* "COMPONENT SIDE" designates the component side foil.

* "SOLDER SIDE" designates the solder side foil.  "SOLDER SIDE" 
  will read correctly when viewed after manufacture (it will be
  reversed in Xray mode).
